Tsurumi UT Submersible Pumps
Tsurumi UT Submersible Pumps feature a vortex (eddy flow) structure and wide pump casing interior, preventing clogging by waste and solid matter.
Vortex Impeller
This impeller is used mainly to avoid clogging or wear by large or stringy solids in the water. It accelerates part of the water to great speed, and this speed is used to smoothly move all the water from inlet to outlet.
Material
ø Discharge bore mm | 40mm, 50mm | |||
---|---|---|---|---|
Pumping Fluid | Temperature | 0-40°C | ||
Type of Fluid | Municipal sewage, water with solids | |||
Pump | Compo- nents | Impeller | Vortex impeller | |
Shaft Seal | Double mechanical seal | |||
Bearings | Shielded ball bearings | |||
Material | Impeller | Plastic | ||
Casing | Grey iron casting EN-GJL-200 | |||
Shaft Seal | Silicon carbide in oil bath | |||
Motor | Type, Poles | Induction motor, 2 poles, IP68 | ||
Lubrication | Turbine oil (ISO VG32) | |||
Insulation | Insulation class E | |||
Motor Protector (built-in) | Circle thermal cut-out | |||
Phase / Voltage | Single phase 230V / 50Hz, 3-phase / 400V / 50Hz / d.o.l. | |||
Material | Casing | Grey iron casting EN-GJL-150 | ||
Shaft | Stainless steel EN-X6Cr13 | |||
Cable | Rubber, 10m H07RN-F | |||
Discharge Connection | Inside thread, JIS10K flange | |||
Optional Accessories | Guide rail fitting "TOK" for small pumps |