Specifications
Flow rate up to 50 l/min (3 m³/hr)
Dynamic head up to 68 m
This new series of submersible pumps is fitted with a patented
anti-seize system (ensuring pump operation, even after being left
idle for long periods), and an oversized motor in a
biodegradable, non-toxic, oil bath.
Pump installation and applications
SK pumps should be used in clean water not containing
abrasive substances.
Their dependability and economical nature make them particularly
suitable for domestic use. they are particularly suited to water
supply applications (in conjunction with a pressure vessel or
“easypress" controller) and for irrigating gardens etc.
SKpumps can be installed in wells with a diameter of no less for
4 inches (4sk) the pump is lowered into the well by means of the
delivery pipe until it is completely immersed (min. 50cm), and at
least one meter from the bottom of the well) care should be taken
to ensure that the pump remains submerged, as pump operation may
cause the level of the liquid in the well to fall. it is
advisable to secure the pump using a stainless steel or nylon
cable connected to the special holes on the discharge head.
Structural characteristics
General characteristics
Discharge head with anti-seize impeller housing (patented) in
brass/stainless steel.
Bronze impeller with radial peripheral blades.
Aisi 304 stainless steel motor body
en10088-3 - 1.4104 stainless steel motor shaft.
Mechanical seal carbon / ceramic on 4sk.
Completely removable and re-windable enclosed induction motor, in
oil bath, with built-in thermal cut-out device (motor protector)
ensures continuous operation at the maximum power required by the
pump, cooled externally by the liquid being pumped. insulation
class f.
Protection ip 68.
Control box with capacitor, bipolar switch and overload cut-out
with manual reset supplied as standard. except 4skm 100e which
has internal capacitor.
10 meters ho7 rn-f neoprene submersible supply cable with
removable connector (15, 20, 30, 40 m cables available on
request).
Check valve incorporated in the pump body
Construction and safety standards in compliance with en 60 335
-1, (iec 335-1, cei 61-150) en 60034-1 (iec 34-1, cei 2-3).
4skm 100e
External diameter 99.5mm for 4 inch wells.
1 inch uni iso 228/1 gas discharge port.
Manufacturer:
Pedrollo Pumps
Please note all pumps are despatched at the earliest available for each manufacturer, this could be 9 -10 working days or more, for updated information please contact our sales office.
For next day delivery, please ensure your order is placed before 2pm Monday to Friday, orders received after 2pm Friday will be processed the next working day as we are closed at the weekend. For any orders after this time that still require next day delivery, please contact the office on 01977 602200.